![]() ![]() Valid color names include: BLACK, RED, YELLOW, ORANGE, GREEN, BLUE, AQUA, FUCHSIA, GRAY, NAVY, PURPLE, SILVER, TEAL, WHITE, DARKRED, DARKYELLOW, DARKORANGE, DARKGREEN, DARKBLUE, PEACH, BUBBLEGUM. * Color: The color can either be a color name, or the RGB value (000000-ffffff), without quotes. These correspond to the LEDs that are lit on the dimmer / switch for each LED in On / Off state. * LED: On Lights, there are 4 LEDs that can be set: Top Button On, Top Button Off, Bottom Button On, Bottom Button Off. NOTE: In 2.5 and later, the text in the ‘Lights List’ also shows the name of the devices, which must be removed to paste into the parameter. You can get this list by using the ‘Lights List’ property on the Properties Page of the driver. This is a comma separated list of just Device IDs. ![]() The parameters for Set Light LED Color include: * Dimmer or Switch List: A list of dimmers or switches whose LED color you wish to change. Select the Radio Button that says ‘Device Specific Command’, and choose ‘Set Light LED Color’. ![]() To set LEDs using this driver, go to ‘Programming’, and select the LED Wizard driver in the ‘Actions’ section of the page. With a single command, you can set the LED color for any LED on any number of Control4 dimmers, switches or keypads. This ‘LED Wizard’ driver allows you to do that. A while back, I was asked by a partner to create a driver that would allow a user to change multiple Control4 light LEDs at one time. ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |